Setting The Clock; Making Coffee - Lagostina Artiste Notice D'utilisation

Setting the clock

• Place the coffee maker on a hard flat surface.
• Connect the power cord to a 120V wall socket.
1) When you plug in the coffee maker for the first time, "1:00 pm" will start flashing
on the display. Fig. 1. Set the time by pressing the HR button (m) to set the hour
and the MIN button (n) to set the minutes. The time will appear on the display.
It will be automatically set after 5 seconds or by pressing the BREW button (k).
2) You can also change or reset the time whenever you wish by pressing the CLOCK
button (w) then adjusting the time by pressing HR (m) for the hours and MIN
(n) for the minutes. The time will appear on the display. Figs. 2 and 3. It will be
automatically set after 5 seconds or by pressing the CLOCK button.
NB: Your clock is now set and will continue to show the time, even when your machine
is in standby mode. If the machine is unplugged or there is a power failure, the clock will
default to 1:00 pm. Repeat the steps above to reset the clock.
• Open the coffee maker lid (b). Fig. 4.
• Fill the carafe (g) with cold or water at room temperature, then pour it into the water
tank (c) Fig. 5.
The number of cups is shown by the water level indicator. Do not exceed 12 cups. Fig. 6.
• Place the carafe (g) with its lid (e) onto the warming plate (h) making sure that it is
properly positioned so as to activate the coffee pouring mechanism. Fig. 9.
• Make sure that the filter holder (i) is inserted. Fig. 7. Insert the permanent filter (j) Fig. 8a
or a paper filter into the filter holder (i). If using a paper filter, make sure it is fully
opened and properly positioned in the filter holder. Fig. 8b.
• Add 1 spoon (v) of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 10.
• If you accidentally pour ground coffee into the water tank, do not start the cycle. Clean
the tank, otherwise the coffee may block the water circuit.
• Close the lid (b).
• Press the ON OFF button (r) to turn on the coffee maker and then press BREW (k) to
start the cycle. The BREW button light will come on to show that the coffee maker has
started the brew cycle. The machine will beep once. Fig. 11.
• Once the cycle has finished, the machine beeps 3 times and the keep warm function
switches on automatically for a duration of 4 hours. At the end of the keep warm time,
your machine beeps 3 times and the BREW button (k) turns off.
Note:
− The amount of coffee in the carafe at the end of the cycle is less than the amount of
water poured into the tank because about 10% is absorbed by the ground coffee and
the filter.
− There is an overflow hole on the back of the water tank. If you add too much water, it
will leak out of this hole.
− Clean the permanent filter between each use or use a new paper filter.

Making coffee

EN
9