Ryobi RM480e Série Manuel D'utilisation page 16

Masquer les pouces Voir aussi pour RM480e Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To set the cruise control:
 While driving the mower forward, press the accelerator
pedal until the desired rate of speed is achieved.
 Press the cruise control button. The light around the but-
ton will illuminate to show cruise control is active.
 Release pressure on the accelerator pedal. Mower speed
should remain constant.
 To release cruise control: tap on the accelerator pedal,
depress the brake pedal, or press the cruise control but-
ton again. The light around the cruise control button will
go out to indicate cruise control is no longer active.
CHARGING THE MOWER
See Figures 7 - 8.
Mower batteries must be charged overnight before first
use. To verify mower batteries are fully charged, check the
battery level indicator.
For best results:
 Do not charge in an area of extreme heat or cold.
 Never charge a frozen battery.
 Mount or place the charger in an area with adequate
ventilation, ideally with the charger in a horizontal position
with the cooling fins facing up.
To charge:
 Make sure both the charger and mower connections are
clean and free of dirt or debris.
 Insert charger plug into charging port on mower, making
sure it is properly connected.
 Connect charger to power supply using normal household
current of 120 V, AC only, 60 Hz. The batteries should
automatically begin to charge.
NOTE: The charger is equipped with a plug featuring a
grounding pin and must be plugged into a matching stan-
dard three-prong outlet that has been properly installed
and grounded in accordance with all local codes and
ordinances. Do not use a two-prong outlet, adaptors, or
modify the plug provided. If it will not fit the outlet, have
the proper outlet installed by a qualified electrician.
 When powered, the LED indicator on the charger will
illuminate to indicate the charger's status. See the chart
that follows to determine the meaning of the LED's display.
 When you are ready to mow, disconnect the charger from
the power supply, then disconnect the charger from the
mower.
NOTICE:
Always turn power switch to OFF position and remove
key when charging mower and when mower is not in use.
OPERATION
CRUISE CONTROL
BUTTON
LED INDICATOR
ON CHARGER
16 — English
Fig. 6
CHARGING
PORT
CHARGER PLUG
Fig. 7
Fig. 8

Publicité

Table des Matières
loading

Table des Matières