Unpacking, Installation And Setup; Unpacking; Installation; Monitor Adjustment - Optelec TwinView Manuel D'utilisation

Optelec

3. Unpacking, Installation and Setup

This chapter helps you unpack, connect and install your TwinView. De DVI and VGA
connections allow you to connect your TwinView to any VGA or DVI compatible device,
such as the Optelec ClearView+, ClearNote+ or FarView.
3.1

Unpacking

Please unpack the TwinView carefully before proceeding with the installation, and consult
the accompanying installation guide. Please contact your Optelec distributor for further
instructions if required.
Your TwinView consists of the following:
- The Optelec TwinView monitor with stand;
- Two VGA cables;
- Two DVI cables;
- One USB cable;
- 12V DC monitor power cable to connect and power the TwinView monitor from
the ClearView+ monitor power socket;
- Adaptor cable to enable use of a standard ClearView+ power supply;
- An installation poster;
- CD containing the TwinView driver software;
- This user manual.

3.2 Installation

This chapter describes how to set up and connect the TwinView and install the TwinView
intelligent split screen software.

3.2.1 Monitor Adjustment

The height and viewing angle of the TwinView can be adjusted to provide a comfortable
reading position. With its stand of 35 cm (13,8 inches) high, 5 cm (2 inch) height
adjustment, 20 degrees pivot and 60 degrees swivel panel adjustment, virtually every low
vision user can adjust the display to their exact comfort level to help reduce eye and neck
strain.
TwinView
Page 9