Cleaning And Maintenance - SPC SPCMG-06SB Mode D'emploi

SPCMG-06SB - SPCMG-06SR
3 seconds and press the button to enter level 1, and repeat the
previous steps.
3. In any gear, press long to enter standby mode.
4. In standby mode, long press can turn it off directly, and it will be
off automatically if there is no operation for 15 seconds.
CHARGING
1. Fully charge battery for up to 6 hours before first use either
attached or detached from the device.
2. To charge, connect DC end of the supplied 24V adapter to the
battery's charging port and plug AC side cable into wall outlet.
3. The LED light on the device flashes regularly, indicating the battery
level, indicating that it is charging.
When the first indicator is on, the remaining capacity of the
•
battery is 20% to 35%;
• When the second indicator light is on, the remaining capacity of
the battery is 40% to 60%;
• When the third indicator light is on, the remaining capacity of the
batter y is 65- 80%;
• When the forth indicator light is on, the remaining capacity of
the battery is 85-100%.
4. Battery may be recharged at any time and at any battery level. Do
not switch on to use this device while charging.
5. The battery needs to be recharged when it runs out to less than
5% (the first LED flashes).
6. The average run-time is 4+hours depending on speed level and
pressure applied during use.

CLEANING AND MAINTENANCE

1. Use slightly damp towel cleaning equipment, wipe dry with a soft
cloth, do not use detergent, strong detergent, concentration more
than 75% of alcohol, disinfectant and other irritating chemicals
wipe clean.
2. For storage or travel, remove battery and store in the supplied
box.
28