Flex FX1371A Manuel De L'utilisateur page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

VARIABLE-SPEED TRIGGER SWITCH
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
In T1 and T2 modes pressing the trigger switch
will deliver the highest rotation speed within
current mode regardless of the pressure exerted
on the switch.
LED LIGHT (FIG. 9)
Your tool is equipped with an LED light, located
on the base of the tool. This provides additional
light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running and will turn
off approximately 10 seconds after the variable-
speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
If the LED fails to light up when you switch on
the tool, or it turns off suddenly during your
operation, it may be caused by the internal
communication error. Please contact customer
service or an authorized service center for
assistance.
(FIG. 8)
Fig. 8
Variable-Speed
Trigger Switch
Fig. 9
-13-

Publicité

Table des Matières
loading

Table des Matières