Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Screen operation
Use the supplied power cord to connect the display to the power supply.
Make sure the power supply is correct (230V / AC). Do not lay the cable on hot
surfaces and avoid unnecessary tension.
Mains connection
already wired 230V/AC
Port RS485
The display comes with an infrared remote control and a radio remote control.
Plug the jack plug into the "External IR Connection" connector on the left side of
the crankcase and align the receiver so that it has free visual contact with the IR
remote control.
Use of commands
1. Press the "Up" button on the remote control. The screen will
2. Press the "Stop" button on the remote control. Screen
3. Press the "Down" button on the remote control. The screen
automatically move to the upper end position and stop
automatically.
movement stops immediately.
will automatically move to the lower end position and stop
automatically.
External IR connection
Trigger input
6
Publicité
Table des Matières
