Pin Assignment - Citizen CD-S500 Série Mode D'emploi

Chapter5 Appendixes
Parallel (IEEE1284) Interface
Timing when power is on
∗RESET
BUSY
∗ACK
SELECT
Drawer Kick-Out Interface

Pin assignment

6 1
The ESC pm t1 t2 commands select either Drawer Kick-out Signal 1 or 2 to set the
pulse time.
Note:
• T2 (when OFF) ≥ T1 (when ON) Ω4 is satisfied.
• The maximum amperage at +24V is up to 1A. When connected to one that exceeds
1A, the printer and connected equipment may be damaged.
50
PIN No. Direction Function
1 – Frame GND
2 Output Drawer Kick-out Signal 1
3 Input Drawer Open/Close
4 – +24V
5 Output Drawer Kick-out Signal 2
6 – Signal GND
T1 x 2ms
When ON
INIT signal timing
A : More than 16µs
A
∗INT
B : Less than 200µs
B
BUSY
∗ACK
∗FAULT
T2 x 2ms
When OFF