ASSEMBLY INSTRUCTIONS
Ѐ
Ѐ
Ѐ
Ѐ
Ѐ
Ѐ
TIGHTENING NUTS & BOLTS
Ѐ
Ѐ
Ѐ
Ѐ
SWINGGERMAN.indd 65
Place the UFO SWING on level ground and not less than
200cm from any structure or obstruction such as a fence,
garage, house, overhanging branches, laundry line, or
electrical wires.
Do not install the UFO SWING over concrete, asphalt, packed
earth, or any other hard surface; a fall onto a hard surface can
result in serious injury or death to the equipment user.
Adequate overhead clearance is essential. A minimum
clearance from ground level shall be recommended. Provide
clearance for wires, tree limbs, and other possible hazards.
For ease of installation, do not over-tighten the nuts and bolts
when you are first putting the equipment together. This will
allow for some possible adjustments during installation.
Once you have finished assembling each component of the
play set, make sure to go back over each step and properly
tighten all nuts, bolts and plastic caps. Check the entire unit
to ensure all parts are properly assembled before allowing
children to use the playground equipment.
65
11/16/2018 3:18:36 PM