Medisana IPL 836 Mode D'emploi page 45

WARNING
• Never emit several light pulses in succession onto the same
area of skin!
• If pain, swelling or other unusual reactions occur during the
application, immediately stop the test and do not carry on
using the device. Contact your doctor.
While transferring the device to other skin areas you can proceed in two different ways:
Method 1: "Gliding and flashing"
Keep the trigger button
in succession as long as the skin contact area
skin. After each light pulse slide the device to the next area. Keep the light
7
area pressed onto the skin. This mode is especially suited to treating
larger areas, such as the legs, for example.
Method 2: "Stopping and flashing"
Release the trigger button
position the device on the area directly next to the area that has just been
treated. Make sure that the light area
fully on the skin. This mode guarantees precise treatment for example of
the knees or ankles.
WARNING
If a device fan fault should occur during the application, imme-
diately stop use of the device, otherwise skin injuries may be
caused by the high heat. Contact the customer service.
After switching the device off take the power supply plug out of the socket and disconnect the
device plug end of the power supply cable from the device. Then clean the device in accord-
ance with section 5.1 "Cleaning, care and storage" in these operating instructions.
NOTE
The device will be switched off automatically after approx. 3
minutes. To continue the application, press the ON-/OFF-button
1
and select the desired intensity.
4
pressed down. The device emits a light pulse
after each light pulse. For the next light pulse
4
7
and the skin contact area
4 Operating
5
is in full contact with the
GB
5
lie
45