Publicité
Fax +1 305 430 9692
2. Charge on base
Place the base on a flat, horizontal, stable surface that is not
exposed to direct sunlight or humidity, and far from any heat
source.
Remov e the rubber cover on the base to access the charging
pins on top of the charging station.
Make sure the appliance is set to off, and all the accessories are
remov ed.
Plug the charger into the side of the base, and then plug it into a
w all socket.
Place the battery into the charging base, making sure that the
connection pins on the base are straight and not crooked. The
battery should insert perfectly into the base
The LED light on the base lights up red, and w ill start blinking, to
show that the battery is charging.
When the battery is fully charged, the LED indicator light should
glow solid red (it w ill no longer blink).
Note: To remov e the battery from the base, simply press the 2
buttons on each side of the battery and lift it out from its cradle.
Note: We recommend keeping your appliance alw ays in charge
w hen not in use, this w ay it w ill keep a full charge and w ill alw ays be
ready for use w hen you need it.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International USA.
The pages must be reproduced and folded in order to obtai n
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numberi n g.
Keep the language integrity.
7
Assembly page 7/32
Print only what is inside the frame.
VC 42475 - 160909
Publicité
