Publicité
10.
SETTING AND USING THE SLEEP FUNCTION
This function will switch off the radio automatically after a preset time
interval.
10.1 With the radio of choice playing, press the SNOOZE / SLEEP button and the
sleep status is shown in the display.
10.2 Press the FORWARD ( ) or BACKWARD (
desired sleep interval (see sequence below) is shown in the display.
10.3 Press the ENTER button to accept. The sleep timer is now activated and
the display will show the sleep indicator (S) and the time interval remaining
before the radio switches off (e.g. 10).
10.4 The sleep function will count down and the unit will switch off automatically
after the time interval selected has lapsed.
10.5 To cancel the sleep timer, press the SNOOZE / SLEEP button and then
press the FORWARD ( ) or BACKWARD (
is shown in the display. Press the ENTER button to accept.
11.
USING HEADPHONES (not included)
A stereo headphone jack has been provided so that the unit can be used
without disturbing others. Plug in the headphones at the point marked „
at the rear of the radio and adjust the listening volume to your chosen level.
Excessive sound pressure from earphones and headphones can cause
hearing loss. The speaker will not operate when earphones are fitted.
12.
RESET
Moving the radio to another location in the country the pre-tuned and stored
stations may no longer be available and it will be necessary to reset the
radio back to the factory settings.
12.1 With the unit switched on, press and hold the MENU / INFO button until the
display shows the „system reset‟.
12.2 Press the ENTER button to confirm reset and „press enter key to reset‟ will
be displayed.
12.3 Press the ENTER button once again to confirm. The radio will display
„system reset‟ and the reset will begin.
12.4 A „full scan‟ will then start and the display will show a slow progressing slide
bar.
12.5 When the scan is finished the radio will play the first alphanumerically
found station. All stored programmed stations will be lost during reset.
Note
If the MENU / INFO ENTER button is pressed again quickly in step 12.1 the
„software number‟ will be displayed.
) buttons repeatedly until the
) button repeatedly until „OFF‟
11
‟
Publicité
