Publicité
5. Mount push button. Use either screws or double sided tape to mount push
button.
• To mount with screws, remove back of case by pushing in tab on bottom
• When attaching push button using double sided tape, make sure the surface
6. Determine cover mounting type. The cover supplied with the chime base
will either snap onto the base or hang from a cover pin.
Figure 5
• Snap-On Cover: Apply pressure to the cover until it snaps into place (see
• Hanging Cover: Before mounting chime base to wall, slide the cover pin
Note: Cover pins are located on two sides of the chime base for use with hanging covers. When
chime base is mounted according to mounting orientation marking, use the cover pin located
on the top of the chime base for hanging the cover.
'D '
P E
T Y
2 0
L R
'D '
P E
T Y
2 0
L R
Snap-On
Cover
Figure 6
All manuals and user guides at all-guides.com
with a small screwdriver. Attach back of case to door jamb or wall. Snap
front of push button on.
of the door jamb or wall is clean.
Figure 6). To remove, firmly grasp cover and pull to remove from base.
that will be on top of the mounted base out of the base. Turn it over so the
pin is protruding above the base. Slide the cover pin into base (see Figure
7). Hang cover on cover pin.
Mounted
Chime Base
X
- R
3 5
- 0 0
T R
Chime Base
-2-
Cover Pin
Figure 7
P E
T Y
C
598-1172-03
Publicité
