English
► What's in the box
®
• Play2Run
UC2 headset
• USB charging cable : USB-DC
• Flat cord Jack-Jack 3,5 mm audio connector
• Carry pouch
• User guide
► Quick start guide
Bluetooth
®
pairing
Make sure that no cable is connected to the 3.5 mm audio jack.
Turn on the headset by pressing more than 5 seconds on the ON / OFF button.
The LED should flash red and blue. The UC2 is now ready to be connected to your Bluetooth
transmitter.
Search on your Bluetooth
device.
The pin code is 0000 (some devices do not require this code)
Pairing is complete when the headset beeps twice, and the blue light flashes.
UC2 headset is now ready to be used in Bluetooth
Using a Bluetooth
®
Receiving a call :
Short press the TEL key to receive an incoming call.
Ending a call :
Short press the TEL key to end a call.
Answer a call in audio playback mode :
Short press the TEL key to receive an incoming call. Playback will pause during your
conversation and restart automatically at the end of your call.
Rejecting a call :
Press the TEL key twice to reject a call..
Redialing the last number :
To redial the number you last called (if your phone supports this feature with the headset),
when no call is in progress, press the multifunction key twice.
Phone conversation :
The microphone is located on the right earpiece, do not block the hole for clarity. You can
increase or decrease the volume with the + and - buttons.
Voice call activation :
If your phone supports this feature with the headset, when no call is in progress, press and
hold the multifunction key for about 2 seconds. Proceed as described in your phone user guide.
► Using the Jack-Jack cable
You can use the headset using the mini 3.5mm Jack cord.
This allows you to continue listening to your music with UC2 without soliciting its battery.
Note that in this case the function settings will not act, only your external drive control.
This also allows to use your headset with devices that are not equipped with Bluetooth
All manuals and user guides at all-guides.com
®
transmitter the Play2Run-UC2 and follow the instructions of your
mobile phone
®
mode.
®
®
.