Publicité
ASSEMBLY (continued)
Easy assembly,
no tools required.
1
Position S-Rod upright.
2
Rotate the LOCKING COLLAR
fully in the counterclockwise
direction.
3
Insert your finger inside the tube and make sure the
INTERNAL CAM LOCK is flush with the inside of the tube.
4
Insert the MIDDLE STEM into the S-ROD,
with the SILVER BUTTON pointed upward
5
Rotate the MIDDLE STEM until the SILVER BUTTON
locates in the hole.
6
Twist the LOCKING COLLAR fully in the clockwise
direction until it locks.
7
Repeat this process on the LOWER STEM.
8
Using the BOLT and KNURLED KNOB, attach the
SEARCHCOIL to the LOWER STEM.
9
Adjust the LOWER STEM to a length that lets you maintain a
comfortable upright posture, with your arm relaxed at your
side, and the SEARCHCOIL parallel to the ground in front of
you.
10
Wind the CABLE securely around the STEMS, leaving slack
at the bottom.
11
Connect CABLE PLUG to housing.
Do not twist the Cable or Plug. Turn Locking Ring only.
Use minimal finger pressure to start the threads. Do not
cross-thread. When the Locking Ring is fully engaged over
the threaded connector, give it a firm turn to make sure that
it is very tight. When the Locking Ring is fully engaged over
the threaded connector, it may not cover all of the threads.
12
Tighten both LOCKING COLLARS.
13
Attach theCABLE with 2VELCRO straps
provided, one at the base near the
SEARCHCOIL, and the other at the
top near the housing.
Do not force the plug because
Caution :
excessive force may
disconnect the cable. Do not pull
damage it. Pull the plug to
the cable.
*
Note: Very tall users can purchase the
optional Extended Lower Stem (TUBE5X),
for extended reach.
Caution:
Forcing in MIDDLE STEM
with CAM LOCK raised
may form a burr on
camlock. If this happens,
remove burr with knife to
allow insertion.
S-ROD
5
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
S-ROD
MIDDLE STEM
2
3
4
MIDDLE
STEM
4
5
Publicité
