Publicité
footrest.
12 FOUR SEASONS SYSTEM: as shown in the figure, it is
possible to adjust the product's air circulation from the
base in order to prevent condensation.
To create a cool, well ventilated environment (in
summer), open the holes by moving the 4 levers
outwards. To limit the entry of air (in winter), move the
levers inwards.
Ganciomatic system
13 Ganciomatic is the quick, practical system that allows
you to attach the Navetta Elite to the Ganciomatic clips
of a stroller or the base of a chassis.
To attach the Navetta Elite, put it on the stroller or the
chassis and press with both hands until it clicks into
place.
Always apply the brakes on the stroller or chassis before
attaching and removing the Navetta Elite.
Check that the bassinet unit is properly attached.
• To release it, raise the lever of the Ganciomatic clip
(arrow_a) and lift up the Navetta Elite (arrow_b).
Removing the lining
14 REMOVING THE HOOD LINING:
- Release the buttons on the side and back of the bassinet
(fig_a)
- Press the hood's attachments (fig_b) and release it
upwards (fig_c).
15 Remove the fabric from the handle to facilitate removal
of the lining (fig_d), and then remove the hood's rigid
components (fig_e).
16 REMOVING THE NAVETTA ELITE INNER LINING:
- Unbutton the foot muff, if attached, and remove it.
- Unfasten all the buttons on the side of the bassinet.
- Lift the inner lining off the backrest and remove the
fabric from the top.
17 REMOVING THE NAVETTA ELITE OUTER LINING:
- Unfasten all the rubber bands as illustrated.
- Remove the outer fabric.
18 WARNING: when replacing the outer lining of the
All manuals and user guides at all-guides.com
bassinet, ensure you fit it on correctly with all external
components left on the outside, i.e.:
rings for fastening the vehicle kit (fig_a),
handle for adjusting the backrest (fig_b),
release handles (fig_c).
19 When placing the lining on the hood, ensure you insert
the rigid supports correctly. Insert the tube bearing the
carry handle into the hood's front slot, ensuring the
handle is centred correctly (fig_a). Pull the flap of fabric
out from the opening on the hood (fig_b) and slide it
under the handle (fig_c).
20 Finally, slip the second metal support into the hood's
inner slot.
21 Push the hood's metal supports into the relevant slots
and fasten the buttons.
Padding cleaning instructions
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not tumble
dry.
Product cleaning
• Before washing, remove the metal plaque on the foot
muff, if present.
• This product requires a small amount of maintenance.
Cleaning and maintenance must only be carried out by
adults.
• Keep all moving parts clean and if necessary lubricate
them with light oil.
• Clean the plastic parts periodically with a damp cloth.
Do not use solvents or similar substances.
• Brush the fabric parts to remove dust.
• Do not clean the polystyrene shock absorbing device
with solvents or other similar products.
• Protect the product from atmospheric agents: humidity,
rain or snow. Extended exposure to sunshine can cause
15
Publicité
