Baril KUI-4 00 Serie Manuel D'installation

Pull down Kitchen Faucet Installation
Do not over-
tight.
7. Hold on to the spray-head hose,
unscrew spray head and remove it along
with the rubber washer. Turn on the fau-
cet to flush the hose and feed line for 1 -
minute to eliminate debris. Turn off faucet
and re-install the rubber washer and spray
head.
2. Insert faucet through center hole, re-install
rubber and metal washers followed by the
locking nut. If removed, reinstall hose con-
nector insuring that the small rubber washer
is also secured. Using a screwdriver, tighten
the locking nut screws so that the faucet is
secured and will not twist.
5. Proper installation of the hose weight kit
will ensure that the spray head retracts
smoothly. On the spray side of the hose,
measure 15" down from the body of the fau-
cet. Install the hose weight kit at this level.
Pull out on the spray head: it should move
easily and retract smoothly. Reposition the
hose weight kit as necessary.
3. Tighten pull-out hose into the
copper pipe. Do not overtight.
6. Attach flexible hoses to water
supply. Do not overtight.
Hot
Check watertightness of all connections.
Cold
Volume control