Publicité
Assembly
1
Attaching the side handle
Attach the side handle D to the rolling cabinet E
using four screws ( ).
NOTE: The holes in the cabinet are tapped and do not
require nuts.
3
Installing the pegboard
NOTE:
This step should only be done after the casters
have been installed.
Attach the pegboard to the back of the cabinet using eight M6 x 12 screws (AA).
( )
( )
AA
E
D
AA
2
Installing the casters
CAUTION: Do not over-tighten the screws.
Ensure all cabinet drawers are securely closed and
the cabinet is locked.
Lay the cabinet (E) on its back. Use the packaging
Mount the two swivel casters with brakes (F) to the
cabinet on the same end as you installed the side
handle (D) using eight screws (CC) and eight
washers (BB) with the hex wrench (DD) included.
Mount the remaining rigid casters (H) to the other end
of the cabinet using eight screws (CC) and eight
washers (BB).
Tighten all bolts with a M6 hex wrench (DD).
Return the cabinet (E) to it's upright position.
H
CC
AA
5
Please use two people for this step for safety.
BB
E
F
Publicité
