Publicité
FX Series
Kar-Tech® Transmitter & Receiver
1.5 Transmitter Sleep Time Programming
The transmitter is set to turn off (sleep) after
25 minutes of non-use. To change the time the
transmitter waits before going to sleep, use this
procedure:
1. Press and hold buttons 3, 4, 5 and POWER (5)
simultaneously.
2. Release the buttons. Both LEDs begin flashing.
3. Press one of the following buttons to adjust the
sleep time:
- Button 1 = 15 minutes
- Button 2 = 30 minutes
- Button 3 = 1 hour
- Button 4 = 2 hours
- Button 5 = Sleep disabled
Sleep time programming completed.
2
4
Fig. 5 – Transmitter
All manuals and user guides at all-guides.com
1.6 Synchronize Transmitter and Receiver
In the event it is necessary to synchronize a new
transmitter and receiver, use the following steps:
1. Turn the transmitter OFF and disconnect power
2. To get the hand-held transmitter to Teach mode,
3. Power up the receiver. (On older models, remove
1
3
4. The green LED stops flashing stays on
5
5. Teach mode is now complete.
00610
5
from the receiver.
press and hold the POWER button for 10 seconds
until both LEDs are flashing.
the cover and place a jumper wire across the
TEACH ID jumper inside the receiver. See
illustration.)
1
2
3
Fig. 6 – Receiver with Cover Removed
1. TEACH ID Jumper (Older Models)
2. Error Code LED – Red
3. Signal indicator – Green
continuously when the new signal is learned.
Remove the wire and store it on one pin.
Remote Winch Control
00611
Publicité
