Publicité
After the connection is completed,
"READY" on LCD indicate a correct status
to start jump start. Start the car and do
not crank over 5 seconds.
ADDITIONAL FUNCTION
Charge Phone QC3.0:
Q C 3 . 0
Wall Plug:
30%
To recharge the device, firstly, connect
the charging output port of the provided
charger ( WJG-Y131400900W) to the
product input port, and then connect the
charger plug to the 230V power supply.
At this time, the percentage in LCD will
display the charging status. After fully
charged, the "Charging icon" on the top
right will be stopped blinking.
LCD
%
2MINS
OFF
After the engine is successfully started,
first pull out the jump start plug (8) of the
device and then remove the clamps from
the car battery, and then long press the
power switch
(4) to turn the unit off.
2 x USB ports (5) compatible with QC3.0
fast charge technology is available on the
side of the jump starter. Connect the USB
cable to the USB output port of the device,
press and hold the power switch (4) for 3
seconds to turn on the unit; the device will
start to charge. The USB output will be
automatically turned off after charging is
completed.
LED Light:
OFF
Press and hold the power switch (4) for
3 seconds to turn on the unit.
- 1st short press: Working light
- 2nd short press: Flashlight,
- 3rd short press: Light Off.
2 Mins OFF:
The device will be turned off automatically
if it is not be used within 2 minutes.
Alternatively, press and hold the power
switch (4) for 3 seconds to turn off the unit.
67
Publicité
