EN
ASSEMBLY
Platter, drive belt, and dust cover installation and stylus cover removal
With clean hands (finger oil could make the belt slip), install the flat drive drive belt as shown in
Figure A, wrapping it around the exterior of the plastic sub-platter and the pulley. Place the
black metal platter over the sub-platter on the turntable and put the Como Audio felt mat on
the top of the metal platter to protect your records. Align the holes in the back of the dust cover
over the hinges on the back of the turntable's base and gently slide the dust cover over them.
Connect the included external power supply to the rear 15V/0.8A input.
The counterweight supplied is suitable for cartridges weighing between 3 - 7g (weight no. 81).
The counterweight is pre-set perfectly from the factory.
> Remove the clear protective cap under the stylus prior to playing a record! Save the cap.
______________________________________________________________________________
Controls, Features, and Connections
16
POWER/SPEED SWITCH (left side)
2
DRIVE PULLEY
13
PHONO/LINE OUTPUT, GROUND CONNECTION
14
PHONO/LINE OUTPUT SWITCH
15
POWER SUPPLY INPUT
All manuals and user guides at all-guides.com
FIGURE C
4