Bresser TemeoTrend LB Mode D'emploi page 30

two minutes, blanks „
are successfully searched. Check the remote unit is sound and
secure. You can wait for a little while or hold [▼] for 2 seconds to
enforce an immediate search. If the temperature goes above or
below than the temperature measuring range of the main unit or
the remote unit (stated in specification), the display will show „
"
4b) HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving status of the
W
main unit. There are three possible forms:
S
The unit is in searching mode.
˚C
Temperature readings are securely registered.
No signals.
4c) MAXIMUM AND MINIMUM TEMPERATURES
The maximum and minimum recorded indoor temperature, out-
door temperatures will be automatically stored in memory.
To display them, Press [MEM] once to display the maximum
readings.
The respective indicators,
[MAX] or [MIN] will be displayed.
To clear the memory, hold down [MEM] for two seconds.
The maximum and minimum readings will be erased.
If you press [MEM] now, the maximum and minimum readings
will have the same values as the current ones until different rea-
dings are recorded.
4d) DISCONNECTED SIGNALS
If without obvious reasons the display of the outdoor temperature
goes blank, hold [▼] for two seconds to enforce an immediate
" will be displayed until further readings
W
S
˚C
30