Publicité
Troubleshooting
• Save all instructions
Problem and Solutions:
PROBLEM
Fails to split logs.
The ram moves unsteady,
makes an unfamiliar noise or
vibrates excessively.
Oil leaks around cylinder ram
or from other points.
Electric motor will
not run.
Technical Service
• Save all instructions
Contact Information:
You may have further questions about assembling, operating, or maintaining this Log Splitter. If so, you can
contact our Technical Service Department at 1-800-737-2112 (English only).
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
Questions? Call Toll Free at 1-800-737-2112
POSSIBLE CAUSE(S)
1. Log is improperly positioned.
2. The sizes or hardness of the
log exceeds the capacity of the
machine.
3. Wedge cutting edge is blunt.
4. Oil leaks.
5. Unauthorized adjustment
was made to the maximum
pressure limiting screw. Lower
pressure rating was set.
1. Lack of hydraulic oil and/or
excessive air in the hydraulic
system.
1. Air sealed in hydraulic system
while operating.
2. Vent screw is not tightened
before moving the Log Splitter.
3. Oil drain bolt with dipstick is
not tight.
4. Hydraulic control valve
assembly and/or seal(s) worn.
1. Motor has encountered
overload and activated the
reset button.
EN - 12
SOLUTION(S)
1. Refer to "Log Splitter Operation"
section (page 9) for perfect log loading.
2. Reduce the log sizes before splitting.
3. Refer to "Sharpening Wedge" section
(page 10) to sharpen the cutting edge.
4. Locate leak(s) and contact the dealer.
5. Contact the dealer.
1. Check oil level for possible oil refilling.
2. Contact the dealer.
1. Loosen vent screw by 3 to 4 rotations
before operating the Log Splitter
2. Tighten the vent screw up before
moving the Log Splitter.
3. Tighten the oil drain bolt with dipstick.
4. Contact the dealer.
1. Push the reset button when motor has
cooled.
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
Copyright © 2018 MAT Engine Technologies, LLC
Publicité
