Publicité
o
I = 50
C
o
II = 400
C
o
III = 600
C
The cold air setting 1 is suitable for cooling a warmed
work piece or for the drying of paint. It is also suitable for
cooling the unit before placing down or the changing of
nozzles.
The air setting 2 is suitable for Bending Plastic and heat-
ing shrinking plastic.
The air setting 3 is suitable for stripping paint and defrost-
ing pipes.
4. NOZZLES (See Fig. A)
The kit is supplied with 4 different shaped nozzles, which
can be used as follows:
1) CONCENTRATION NOZZLE (See Fig. A)
This nozzle directs a concentrated heat flow to the work-
piece. It is ideal for use when removing paint in awkward
corners, crevices, mouldings, beading, architraves or
whenever precise paint removal is required.
2) HOOK NOZZLE(See Fig. B)
This nozzle disperses the heat flow evenly around the
whole workpiece. It is ideal for defrosting frozen pipes,
soldering pipe work, bending plastics and heat-shrinking
electrical parts.
3) FLAT NOZZLE(See Fig. C)
This nozzle directs a long narrow heat pattern to the
workpiece, and is ideal for removing paint or varnish from
large flat surfaces such as skirting boards, doors, stairs
etc. It should be used in conjunction with a flat scraper.
Vinyl tiles can be removed by softening the tile and adhe-
sive.
4) GLASS PROTECTION NOZZLE (See Fig. D)
This nozzle for deflecting air flow. On profiled surfaces,
varnish can be removed using an appropriately fitting
spatula and brushed off with a soft wire brush.
5) SCRAPER(See Fig. E)
Take the handle from the set, remove the nut from the
end, and fit the triangle blade in place by refitting and
tightening the nut. The triangular shave hook is ideal for
stripping paint from flat wooden surface and edges.
Remember to clean the blade after use with wire wool
and lightly oil before storing.
202116 2000W Heat Gun
500 l/min
250 l/min
500 l/min
17
SAFETY AND OPERATING MANUAL
Publicité
