Publicité
OPERATING INSTRUCTIONS
1.
Place the unit on a flat and stable work surface.
2.
Be sure unit is fully Cleaned and Assembled (see Assembly
Instructions and Cleaning Instructions).
3.
Do not operate the appliance continuously for more than 10 minutes,
if you do operate longer allow the appliance to cool for 30 minutes
before second operation.
4.
Make sure the Switch is in the "OFF or UP" position. Always reach switch
by entering from the back of the unit, keeping hands away from blade.
5.
Insert plug into standard 120 Volt electrical outlet, rated 15A minimum.
6.
Slide the Food Tray backward until it locks or slide out to remove
and place on supporting surface.
7.
Place food on Food Carriage, between the Support Plate and Slicing
Guard. To avoid risk of injury, always use Food Carriage and Slicing
Guard while cutting.
8.
Set the Thickness Adjustment Knob to the desired thickness to be sliced.
9.
Start the Motor Assembly by sliding the Safety Lock and pressing the
ON/OFF button. The safety lock prevents accidental engagement.
10. Grasp the Slicing Guard with one hand and gently push food into
Support Plate while sliding Food Carriage towards Blade. When
food has cleared Blade slide Food Carriage back to starting
position. IMPORTANT - NEVER PUT YOUR FINGERS INTO
THE BLADE WHILE UNIT IS OPERATING OR PLUGGED INTO
ELECTRICAL OUTLET.
11. To avoid injury wait until the blade has stopped moving before cleaning.
12. When you have finished slicing food, press Switch to "OFF or UP",
unplug from electrical outlet and follow cleaning instructions.
13. For safety, return the Blade Guard over the Blade and adjust
slicer thickness to "0" setting to protect Blade edge.
CLEANING INSTRUCTIONS
1.
Unplug cord from wall outlet.
2.
NEVER immerse the Motor Assembly in water or other liquid.
3.
All parts, except Motor Assembly are dishwasher safe. Always
use care when handling the Blade while cleaning.
4.
Remove Motor Assembly, instructions on page 4.
5.
Clean outer surfaces of Motor Assembly with damp cloth. Do not
use steel wool, abrasive cleaners or sharp utensils.
6.
After cleaning and drying all parts, replace all parts in reverse
order of removal, follow ASSEMBLY INSTRUCTIONS.
All manuals and user guides at all-guides.com
5
Publicité
