Publicité
Size - A5
English
• Place the product with the lower drain
outlet above a suitable container or a drain.
• Remove the cover of the lower drain outlet.
• Attach the cover of the outlet again, when
all water is drained.
• Connect the plug to a suitable socket.
• The product is ready to be switched on.
Under some circumstances (e. g. high humidity)
the self-evaporation system may not be
sufficient to handle the water and excessive
water is collected in the internal tank, which
must be drained as described above when full.
Activation, installation and use of
WLAN/IoT functions
For activation, installation and use of WLAN
/ IoT functions, please refer to the separate
instructions with the corresponding title.
Cleaning & care
Fig.
Switch the product into Standby and
12
unplug in order to disconnect from the
mains.
Note:
Clean the product every two weeks. Clean
the outer surfaces of the product with a
damp cloth soaked in neutral detergent. Dry
it with a lint-free cloth. Do not use chemical,
alkaline, abrasive or other aggressive
detergents as they might be harmful to the
surfaces.
48
IM_KAC12020WIFI_191120_V02_HR.indb 48
All manuals and user guides at all-guides.com
Fig.
Remove the air filters. Clean the air
13
filters in warm water (below 40 °C) with
neutral detergent.
Fig.
Let them dry thoroughly before re-
14
attaching.
• Do not open the housing of the
product and do not insert any objects
into the air vents.
• This product does not contain any
parts that can be repaired or serviced
by the consumer. Contact a qualified
specialist to have it checked and
repaired as necessary.
Decommissioning
Fig.
Drain all water from the product and
15
dry it using the fan mode Fan for half
a day in a dry, warm room to prevent
mold. Switch the product into standby.
Unplug and fix the power cord with the
cable tie to the back of the product.
Remove the exhaust hose assembly
from the product. Cover all drain outlets.
Remove the batteries from the remote
control. Close the cover of the wall
adaptor.
Transportation
Fig.
Wait at least 2 hours after moving the
16
device before operating the product
to avoid damages on the refrigerating
circuit.
Note:
The product is heavy. Therefore move the
product whenever possible by pushing or
pulling it, rolling on the castors. When lifting
is unavoidable, use the recessed handles
and lift with two people. Do not move the
product during operation.
25/11/2019 08:54
Publicité
