Publicité
Gimbal Adjustment Screws
The adjustment points for the iX14+ are located around the
face of each gimbal.* This arrangement allows for quick and
easy adjustment without removing the back cover.
The available adjustments include:
• Mode Change
• Throttle Ratchet
• Throttle Tension
• Stick Tension
Centering
1
2
Ratchet Set
Tension Set
3
Vertical Spring Tension
4
Horizontal Spring Tension
5
Throttle Limit Switch
6
Throttle Limit Adjustment For Transmitter Mode Change
Throttle limiting is used to limit the maximum
travel of the throttle stick when changing between
modes 1 and 2, or between modes 3 and 4.
1. To disengage throttle limiting on the current
throttle gimbal, using a 2mm hex driver, loosen
the throttle limit switch screw one turn. Do not
remove the screw.
2. Slide the throttle limit switch to the opposite
side of its current position.
3. Tighten the throttle limit switch screw.
4. To engage throttle limiting on the desired gimbal, using a
2mm hex driver, loosen the throttle limit switch screw one
turn. Do not remove the screw.
5. Slide the throttle limit switch to the opposite side of its
current position.
6. Tighten the throttle limit switch screw.
www.modellmarkt24.ch
NOTICE: Always perform a stick tension test while turning
the screws to ensure stick tension is not too loose or too
tight. Overtightening a screw can damage the spring.
Loosening a screw too far can cause a spring to fall out in
the transmitter and possibly damage the circuitry within.
*The gimbal adjustment screws are covered by small rubber
plugs. Carefully remove these plugs prior to making adjustments.
The plugs are not interchangeable. Ensure to note from where
each plug is removed and replace them accordingly.
4
5
6
1
2
6
9
3
2
3
Throttle limit
switches
EN
6
1
5
4
6
Publicité
