Publicité
EN
MANUAL OF INSTRUCTIONS
SAFETY INSTRUCTIONS
ATTENTION
These instructions and the recommendations for
use specific to each tool must be made available
to users. They must be read carefully and per-
fectly understood before using, maintaining or
repairing the tools.
They are not exhaustive and must be kept up to
date. It is important to keep them carefully and
ensure that they are always available. Failure to
comply with these instructions may result in inju-
ries or damage to the tools and may invalidate
the guarantee.
TECHNICAL SPECIFICATIONS
Square Drive
Aire Inlet
Max . Troque
Free Speed
Avg . Air Consumption
Working pressure
Sound intensity
Hammer system
Speeds
Strokes per minute
Weight
Dimensions (LxAnxAl)
Work area
Ensure that any items (cables, hoses, leads, etc.)
which may interfere with your work while using a
pneumatic tool are removed from your work area.
Compressed air
High pressure compressed air is very dangerous.
Never point a compressed air jet at yourself or at
anyone nearby.
- When you connect a pneumatic tool, check
that the couplings, hoses and seals operate co-
rrectly.
- When you change to another accessory, re-
member to always disconnect and bleed the tool.
- Never exceed the maximum pressure indicated
in the manual under any circumstances.
Projectiles and dust
Goggles, dust masks and work gloves are highly
recommended while using pneumatic tools.
Entanglement
Pay particular attention to anything which might
become entangled in a rotating part (acces-
sories, loose clothing, etc.).
Precautions:
Depending on the work performed, take account
of the direction of rotation, pay attention to pro-
1/2"
jections and avoid running the drill when not un-
der load.
1/4"
Regularly check that the grinding wheels are
mounted correctly.
1750Nm
7000RPM
Vibrations
If you are exposed to vibrations on a repeated
6,71CFM
or prolonged basis, or if your posture is poor, you
(190L/min)
may feel numb or tingling sensations. If the vibra-
6,2BAR
tions are too strong, you are at risk of temporarily
losing sensitivity in your hands.
107dB
Stop using the tool and consult a doctor.
Doble/Twin
Noise levels
4
Always wear ear protection.
Excessive noise levels may result in loss of hearing.
1100
2,15Kg
Preparing tools not connected to the air network:
Hold the spindle with the angled service wrench.
188x61x186mm
Loosen the collet chuck.
Insert the shaft on the selected accessory into
the chuck.
Use the two service wrenches to tighten the collet
chuck firmly.
Use:
Connect the tool to the air supply network defi-
ned above.
Hold the impact wrench firmly.
Release the safety catch then pull the trigger
against the grinder body to start the grinder.
The rotation speed can be set adjusting the re-
gulator opposite the valve controlled by the tri-
gger.
· 4 ·
REF. 54521
Publicité
