Publicité
Filler Material Warning
• Do not overfill the burner area with rock or glass filler; use only the specified amount. The
depth of the filler should not be more than 1 inch (2.54 cm) above the burner tube. Only
Real Flame filler products have been certified and tested for safe use with this Real Flame
fireplace. Using other filler material may result in increased popping and cracking or increased
carbon monoxide emissions.
• Do not light or use this fireplace if the filler is wet. Ensure filler is completely dry before lighting.
Intense heat can cause wet filler to explode and hit someone causing property damage,
serious injury, or death.
• Keep away from the fireplace for at least 20 minutes during initial start-up as filler could
retain moisture from manufacturing and shipping.
WARNING
!
If the table is installed with a portion of the hose under the table, the hose
must be secured, so that no part of the hose will be within 1" or come in
contact with the underside of the burn pan or where the hose will not be
accidentally damaged or pinched.
Failure to secure the hose in a safe location may result in a gas leak that could
cause property damage, injury, or death. Follow all other hose inspection
instructions listed in this manual.
WARNING
!
Before using this fireplace, make sure you have read, understand, and are following all information
provided in this manual. Failure to follow these instructions could cause property damage,
serious injury, or death.
Checking for Leaks
1. Make a leak check solution by mixing 1 part dishwashing soap with 3 parts water in a spray bottle.
2. Make sure the control knob on the fireplace is in the "OFF" position, then connect your
fireplace to the LP gas tank and turn the tank's valve on.
3. Spray the leak solution on the valve connections, paying particular attention to the areas
indicated by arrows in the diagrams below.
4. If bubbles appear, turn the LP gas tank o , disconnect the tank, and inspect all connections,
making sure threads are clear of debris. Reconnect the LP gas tank and retest. If you continue
to see bubbles, turn the LP gas tank o . Disconnect the hose and call Real Flame Customer
Service at 1-800-654-1704 for assistance.
5. If no bubbles appear after 1 minute, wipe away excess leak solution and proceed to
"Lighting Instructions."
Pay close attention to the
areas indicated by the arrows.
ASSEMBLY INSTRUCTIONS
PRE-USE INSTRUCTIONS
11
The hose should not come within 1"
from the bottom of the burn pan.
1"
Publicité
