Publicité
TECHNICAL SPECIFICATIONS
Model
Voltage
Protection class
Amperage
No-load speed
Max Depth Cut
Max Rabbet Depth
Planing width
OPERATION
WARNING! Before setting up the machine, be sure that the plug is disconnected from the
power supply and that you have a thorough understanding of all safety warnings and
regulations.
Switching on /off:
1) Switching on:
First press the safety lock-out (1)
Then press and keep pressed the ON/OFF switch (2).
2) Switching off:
Release the ON/OFF switch (2)
ATTENTION! For safety reasons the ON/OFF switch (2) cannot be locked in the
ON position.
Adjusting the cutting depth:
The rotary control (13) can be used to set the cutting depth in steps from 0-3/32"
according to the cutting depth scale (14).
Vacuum extraction of dust/debris (see fig. A):
Warning! Before you carry out any work on the tool always pull the mains plug out
of the mains socket.
Planing debris removal port (right/left selectable):
1)
Release the planing debris removal port (3) by turning it against the direction
of the arrow (out of the "Lock" position).
2)
Pull the planing debris removal port (3) out of the tool.
3)
The planing debris removal port (3) can be set to face left or right in the
planer.
4)
Push the planing debris removal port (3) into the tool.
5)
Lock the planning debris removal port (3) by turning it into the "Lock" position.
22
PT101008
120 V - 60 Hz
Classe II /
6 A
16,000 RPM
0 -- 3/32"(2.4 mm)
9/16"(15 mm)
3 -1/4"(82 mm)
Publicité
