Kaldewei DUO POOL 150 Série Instructions D'installation page 3

Table des Matières

Publicité

BATHTUBS WITH PANELLING SYSTEM
Take a little time and read the mounting instruc-
tions of the bathtubs with panelling carefully.
In these mounting instructions, the pictograms
described below are used. They refer to instruc-
tions and notes which require your special atten-
tion.
EXPLANATION
• Kaldewei prepared these mounting instructions
to the best of its knowledge.
• Kaldewei reserves the right to change the con-
tents of the mounting instructions without be-
ing obliged to inform any third parties.
NOTES
Transport the bathtub with panelling in
its transport box only and avoid improper
loads.
Kaldewei shall not assume any liability for
damage incurred due to improper inter-
mediate storage and improper transport.
The installation must be carried out by an
authorized sanitary shop.
All work has to be carried out using spe-
cial technical tools.
When mounting the bathtub, protect the
surface and panelling of it as well as the
wall and floor tiles from damage.
2
Instructions and notes which guarantee
the perfect function and smooth installa-
tion of bathtubs with panelling.
• Kaldewei reserves the right to modify and
improve the technical system without being
obliged to inform any third parties. Please read
the attached additional information, if neces-
sary.
• No part of these mounting instructions may be
reproduced or transferred otherwise without
the express approval of Kaldewei.
Observe the manufacturer's instructions
when mounting the siphon trap.
Avoid soiling of any kind and, in particular,
soiling which might cause clogging of the
drain.
The ground has to be dustfree, fat-free
and dry when glueing on the bathtub car-
rier and/or the bathtub.
The adhesive (silicone/2-components PUR
foam) to be applied must be suitable for
use with styrofoam. The general manufac-
turer's instructions have to be observed.
To prevent the adhesive from hardening
during the individual steps, all the steps
have to be taken in direct succession (ob-
serve the drying times of the adhesive).
D
GB
F
I
E

Publicité

Table des Matières
loading

Table des Matières