Publicité
Tank
Always fill the tank with half demineralized water.
Water level indicator
Lights up when the tank is empty. Fill the tank to
the top.
ON/OFF
Turn the knob to the right to turn on; left to turn off.
Indicator light
Lights up when the steamer is on.
Medium mode - default (cotton, wool)
The indicator light will flash for 2 min. When the
LED lamp stops flashing, the steamer is ready
for use.
Switching to another mode takes a few seconds
(the LED lamp flashes, then stops flashing).
Eco mode (silk, light fabrics)
Press the button once to activate the Eco power
mode.
A/ Max mode (denim, linen)
Press the button once to activate the Max power
mode.
B/ Dry-cleaning mode (very thick fabrics)
To be used only for horizontal ironing. Press and
hold the button for 3 sec to activate this mode.
Once it is activated, the LED lamp flashes quickly.
Warning : The Dry-cleaning mode has a very
powerful steam flow. Use it carefully to avoid burns.
A small quantity of water may be present under the unit, but
this is normal. This is due to the process of decompression
of the tank, releasing pressure from the bottom of the unit.
All high-pressure devices include a safety device that triggers
when a certain accumulated pressure is exceeded.
English
Steam activation
Steam output control button :
press the button to control its output.
Warning: A 5s pause is triggered every 15s of
continuous steam, for cooling.
Drain indicator
To make sure that the steamer remains covered by
the warranty, drain the device to remove limescale
from the heating system.
As soon as the white indicator light lights up, the
steamer must be drained. The steam is no longer
available until the draining is carried out.
Draining procedure
How to proceed:
- Wait until the steamer cools down (minimum 2h
after use), then unplug it;
- Unscrew and remove the yellow plug (located
under the steamer) to empty the limescale inside
the steamer. This should be done over a container;
- After emptying, screw the knob back on tightly to
avoid leaks. Turn the steamer back on and press
the maintenance button (9) for 2 sec to reset it.
Spray head - maintenance
When the steamer is cooled down and unplugged,
fill a container with white vinegar. Soak only the
metal surface of the head for 1h, then rinse with
fresh water and a soft cloth.
Use the cleaning brush to remove limescale
deposits from the steam vents.
Warning: If water leaks into the steam head,
please perform the draining procedure.
If you have any problems with the product, please visit www.steam-one.
com or contact our service department at info@steam-one.com
03
Publicité
