Publicité
Installation Instructions
Install Projector with Attached Interface Bracket
1.
Orient projector with attached interface bracket so that it is
square to the screen. ((Siehe Abb. 3)
2.
Lift the projector and install it to the four studs extending
from the BM-9005U housing. ((Siehe Abb. 3)
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
Ensure that the BM-9005U housing is seated in slots on HB
bracket!
3.
Tighten the four 5/16" flange nuts. ((Siehe Abb. 3)
x 2
3
1
Figure 3
Adjustments
WARNING:
MOUNTING HARDWARE IS TO BE
LOOSENED ONLY ENOUGH TO ALLOW FOR
NECESSARY MOVEMENT. Over-loosening or removal of
mounting hardware may result in personal injury or serious
damage to equipment!
Horizontal Adjustments ((Siehe Abb. 4)
1.
Loosen, but do NOT remove, the four nuts holding the top
slide bracket on the BM-9005U mount.
Adjust BM-9005U mount up to 1-1/2" in any direction.
2.
3.
Tighten the nuts loosened (in Step 1) on the top slide
bracket.
All manuals and user guides at all-guides.com
Example Only
(Interface bracket varies
dependent on projector
model)
2
x 2
3
2
(Interface bracket
Top slide
and projector not
bracket
shown)
Figure 4
Roll (Horizontal Tilt) ((Siehe Abb. 5)
Loosen three bolts on each end of the BM-9005U mount.
4.
Turn adjustment bolts (one at each end of BM-9005U mount
5.
as required.
top)
•
Turn CLOCKWISE to raise
•
Turn COUNTERCLOCKWISE to lower
Securely tighten three bolts on each end of BM-9005U mount.
6.
4
6
RAISE
x 2
5
4
LOWER
6
Figure 5
BM-9005U
1
x 4
3
(Interface bracket
and projector not
x 3
shown)
x 3
5
Publicité
