Publicité
BM-9005U
INSTALLATION
The BM-9005U mount is designed to be mounted to:
•
a 1-1/2" NPT or NPSM following ANSI/ASME B1.20.1
(Schedule 40, 0.154" minimum thickness aluminum-
ASTM B221) threaded extension column; or
•
a UL Listed LPK-1 low profile mounting kit.
Proceed to Installing BM-9005U Mount to NPT Extension
NOTE:
Column section or Installing BM-9005U Mount to
LPK-1 Mount Kit section, as appropriate.
Installing BM-9005U Mount to NPT Extension Column
IMPORTANT ! : These installation instructions assume
that a 1-1/2" NPT or NPSM (Schedule 40, 0.154"
minimum thickness aluminum - ASTM B221) pipe (not
included) has been properly installed and is in place.
Thread the BM-9005U mount (A) onto the existing 1-1/2" NPT
1.
pipe until tight with a minimum of four threads engaged.
((Siehe Abb. 1)
Ensure that long edge of BM-9005U mount is located parallel
NOTE:
to the screen. ((Siehe Abb. 1)
Tighten the 5/16-18 x 3/8" set screw (C) into the BM-9005U
2.
mount threaded collar to prevent movement of the
BM-9005U. ((Siehe Abb. 1)
NPT
pipe
(A)
3.
Proceed to Projector Installation section.
Installing BM-9005U Mount to LPK-1 Mount Kit
Install BM-9005U mount (A) to LPK-1 low profile mount kit (not
1.
included) following instructions included with LPK-1 mount
kit.
4
All manuals and user guides at all-guides.com
2
1
Figure 1
INSTALLING PROJECTOR
IMPORTANT ! :
interface brackets (INCLUDED). (See Parts drawing.)
Install Interface Bracket
WARNING:
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURTY OR DAMAGE TO EQUIPMENT. DO
NOT substitute hardware. Use only the hardware provided by
the manufacturer.
Secure interface bracket to BM-9005U using installation
1.
instructions and hardware provided with interface bracket.
((Siehe Abb. 2)
(C) x 1
Installation Instructions
Model BM-9005U uses "HB" Series
IMPROPER INSTALLATION CAN LEAD TO
Example Only
(Interface bracket varies
dependent on projector
model)
1
Figure 2
Publicité
