Switching On The Gas Burners - De Dietrich DPE7549 Guide D'installation Et D'utilisation

1 1
• •
INSTALLATION
2.1 - SWITCHING ON THE GAS
BURNERS
The gas burners operate safely due to a
metal tab right next to the flame. Each bur-
ner is controlled by a tap fitted with a sa-
fety system which, if the flame accidentally
goes out (spills, draughts, -etc.) the gas
inlet is quickly and automatically switched
off and gas is prevented from escaping.
Each burner is supplied from a tap, which
is opened by pressing and turning the
knob anti-clockwise.
The "0" point corresponds to the tap
being off.
• Choose the desired burner by using the
symbols located near the knobs (e.g.:
right rear burner
• To light a burner:
- Press the knob and turn fully anti-
clockwise .
- Holding the knob pressed will cause a
series of sparks until the gas lights.
- Adjust the setting by turning to between
the symbol and symbol
If the flame goes out, light it again
normally, following
instructions.
The burner flames are smaller near the grid
supports to protect the enameled grid.
The noise made by some burners is the
result of their high power and burning
gas; this in no way adversely affects
cooking quality.
If the flow is interrupted, place a match
close to the previously lit burner. Press
the knob and turn fully anti-clockwise
) (2.1.1).
.
the lighting
Hold the knob pushed in fully for a
few seconds after the flame appears,
so as to trigger the safety system.
• Adjust the ring of flames so that it does
not overflow the edge of the pan (2.1.2).
• Do not use a pan with a concave or
convex bottom (2.1.2).
• Do not use pans that partly cover the
knobs (2.1.3).
• Do not leave the gas on under an empty
pan.
• Do not use heat regulators, toasters,
griddle pans or stewpot with feet which sit
on or touch the glass top (2.1.4).
Keep all natural air-vents in the room
open or
ventilation
mechanically
Prolonged, intensive use of the hob may
require extra ventilation, for example, by
opening a window, for example, or more
efficient ventilation by increasing the level
of mechanical ventilation, where fitted (a
minimum air input of 2 m3 per hr per kW
of gas power is required).
Example: 60 cm - 4 gas burners.
Total power:
1.5+ 2.25 + 3.1 + 0.85 = 7.7 kW
7.7 kW x 2 = 15.4 m3 per hr minimum
flow.
.
27
have a mechanical
system installed
ventilated
(a
hood).