Télécharger Imprimer la page

Oursson CH3010 Manuel D'instructions page 10

Publicité

All manuals and user guides at all-guides.com
ELEMENTS OF DESIGN, Рiс. C
On/Off sensor
Pin for setting knives
Power button. Use the button to turn on the cooking
process.
UTILIZATION
Before first use, wipe the body
the bowl
, lid
and knives
some detergents. Dry. Wipe with clean dry cloth. Before
assembling and disassembling the device, make sure
it is unplugged.
ORDER OF OPERATION, Рiс. D
1. Carefully, holding the plastic base, install the upper
knife on the lower one and turn it counterclockwise,
Pic. D-1.
2. Holding the plastic part, install the knives into the
glass bowl, Pic. D-2.
3. Prepare the necessary ingredients and place them
into the chopping bowl, Pic. D-3.
4. Place the lid so that the arrows on the lid are matching
handles on the bowl, Pic. D-4.
RECOMMENDATION ON PREPARATION
• Before chopping, it is recommended to cut ingredients into 2x2x2 cm cubes. The maximum amount of ingredients in the
table is shown for information purposes only. The recommended chopping duration - from 10 to 30 seconds. You can
increase or decrease the chopping time if you want.
Maximum amount of
Product name
the product
Onion
150 g
Garlic
150 g
Bread Croutons
100 g
Nuts
150 g
Hard Cheese
160 g
Meat
230 g
Chocolate
100 g
Fruits/Vegetables
200 g
Parsley
40 g
CLEANING AND MAINTENANCE, Рiс. E
Clean all the parts of the device immediately
after use.
• Unplug the device. Remove the motor unit. Open the
bowl's lid. Carefully remove the knives, holding the
plastic part. Disassemble the knives by turning the
upper knife clockwise, and then remove him from the
lower one.
POSSIBLE PROBLEMS AND SOLUTIONS
Possible problems
The device isn't turning
on
The device stopped
during operation
10
with a dry cloth. Wash
in a worm water with
Time, sec.
15 sec.
10 sec.
10 sec.
30 sec.
15 sec.
15-25 sec.
10 sec.
15 sec.
20 sec.
Possible causes
No voltage in the socket
Motor overheating
5. Place the motor unit into the lid's opening. Make sure it
is set straight, Pic. D-5.
6. Plug in the device.
7. Slightly press the motor unit to lock it properly, and hold
it during the device's operation. Press
hold it during chopping, Pic. D-6.
8. After chopping, unplug the device. After that, you can
disassemble the device.
Maximum time of continued use of the device
– 30 seconds. The interval between the cycles
should be 10 minutes.
Do not chop ingredients whose temperature is
above 80 °C. Let them cool.
The amount of ingredients must not exceed
"MAX" mark.
Note
Cut the onions beforehand on 4 parts.
Remove the shell.
Cut into 2x2x2 cm cubes.
Remove bones, fat, tendon. Cut into 2x2x2 cm cubes.
Remove the pits.
• Wash the lid
, bowl
soapy water. They can be washed in a dishwasher.
The water in the dishwasher must not be higher
than 60
C.
o
• Wipe the motor unit with damp soft cloth.
• Never immerse the motor unit in water due to
the risk of electric shock.
• Thoroughly dry all the parts after cleaning.
Solutions
• Unplug the device and wait until the voltage recovers.
• Maximum time of continued use of the device – 30 seconds.
button and
and knives
in a warm

Publicité

loading