Télécharger Imprimer la page

Intex CL1704 Manuel D'utilisation page 4

Masquer les pouces Voir aussi pour CL1704:

Publicité

Operation:
1. Make sure the USB receptacle is securely
covered with the rubber flap first. See fig 6.
Slide the switch to "1" first then place the
vacuum in the water.
The vacuum body will not operate unless it is submerged in water. Water flow
from sides of the vacuum body indicates the product is working.
2.
Carefully "sweep" the surface of the spa or pool to remove debris.
3.
Check and empty the filter bag/micro-filter bag regularly during and after each use.
4.
Reverse the above installation steps to remove and empty the filter bag/micro-filter bag.
Note: Rinse vacuum body, cover and filter bags with a garden hose before reassembling.
Maintenance and long term storage:
1.
Turn off the vacuum before cleaning, servicing and maintenance. Regularly check all
components for sign of damage. Discard and replace damaged components immediately.
2.
Using the installation instructions in reverse, disassemble the vacuum. Clean all the
components with water, and make sure all components are thoroughly dry before storage.
3.
Store the product and accessories in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
4.
The original packing can be used for storage.
TROUBLE
VACUUM DOESN'T
WORK
LOW SUCTION
CHARGING FAILED
SAVE THESE INSTRUCTIONS
(286IO) RECHARGEABLE HANDHELD VACUUM ENGLISH SIZE: 4.875" X 7.25" 11/20/2023
IMPORTANT
• Charge the product then turn on the unit. Ensure the unit is
switched to "1".
• Keep the vacuum body under the water.
• Choose the suitable bag for filtering and install the filter
bag(s) correctly.
• Check and empty the filter bag(s) regularly during and after
each use.
• Check for any sand or deposits in the vacuum.
• Contact Intex Service Center.
• Check the plug charger has an output voltage of 5-5.2V ± 0.1,
1A.
• Connect USB cable to plug charger USB receptacle and plug
the charger into the main electrical outlet first, then connect
USB cable into the vacuum body charging receptacle.
• Tighten USB cable, the indicator should be on.
Page 4
Fig 6
SOLUTION
286
IO

Publicité

loading