Publicité
Before use
Mixing conditions vary depending on the type of clay, its hardness as well as the amount of water added. To recycle
clay properly, familiarize yourself with this unit's operations. Carefully read the instruction manual before use.
Principle for recycling of clay
Mixing conditions vary depending on the type of clay, its hardness as well as the amount of water added. To
recycle clay properly, familiarize yourself with this unit's operations. Carefully read the instruction manual
before use.
To vacuum pump
Operation
Power switch
(breaker)
Selector switch
Power switch (breaker)
Selector switch
Screw speed control
Vacuum pump switch
Unplug the power cord from the outlet in an emergency. The power cord also works as a breaker.
* Install the unit properly so you can access the power cord immediately in an emergency.
* Always start with the selector switch in the STOP position when turning ON the unit. The auger screw will not turn if the
selector switch is set at MIX or PUG. If it is in either position, set the selector back to STOP, then set to either MIX or PUG.
* I f the unit shuts down due to overload or the indicator is showing an error (e.g., OL1), set the selector switch to STOP.
This will reset the error, allowing you to restart the operation.
Vacuum chamber
Switch panel
Function of each switch
Turns the power ON/OFF. Automatically turns OFF in the event of an
electrical overload or the like.
MIX
Mixes clay with water.
STOP
Stops the auger screw; resets any current error
PUG
Extrudes clay
Controls the screw speed.
Turns ON/OFF the vacuum pump.
(When the case is vacuum inside, the vacuum pump may be inoperable.
To turn OFF the vacuum pump after the vacuum operation and then turn
it ON again, open the vacuum stopcock to achieve normal pressure and
then turn ON the vacuum pump.
Gap between hopper cover and case
Air intake
Vacuum pump switch
Screw speed control
English
8
Publicité
