Publicité
USAGE GUIDE:
1. Charge your Eye Rejuvenator Device for 4-5 hours before
using it for the first time.
-Charge by inserting the AC adapter into the charging socket (refer to di-
agram on page 4) and plug into a wall socket. The red light will flash to
indicate the battery is charging. When fully charged, the red light will stay
on. Once charged, unplug the cable; do not keep the charging cable con-
nected to a power source when not charging the device. Once the battery
begins to run low again, the red light will flash repeatedly to alert you it is
time for a re-charge. *NEVER OPERATE THE DEVICE WHILE IT IS PLUGGED IN.
2. Turn on by holding down the on/off button for 0.5 sec-
onds. Once the blue indicator stops flashing, the device is
ready to use. Note: The treatment tip will be very warm.
Blue Indicator
3. Make sure skin is freshly cleansed and toned, then apply
an eye serum or preferred product around the eye area—
eyelid, corner of the eye, & under the eye.
4. Hold the device, making sure that your hand is making
direct contact with the silver contact plate (this maintains
the microcurrent connection) and slowly and gently glide
the device from the outer corner to inner corner of your eye,
pausing for 3-5 seconds on acupoints (refer to diagram).
When the device beeps, switch to the other eye. The de-
vice will turn off by itself after treatment.
5. Follow up by proceeding with your regular facial regi-
men—such as additional facial serums, moisturizer, and dai-
ly SPF.
Publicité
