Publicité
3-5. Connecting Weld Cable
1
2
3-6. Installing And Threading Welding Wire
1
WOOD
OM-224 789 Page 12
All manuals and user guides at all-guides.com
3
4
2
6 in
(150 mm)
Pull and hold wire; cut off end.
Tighten
Clockwise
Rear View
3
Hold wire tightly to keep
it from unraveling.
1
User-Supplied Weld Cable
Follow wire manufacturer's recom-
mendations for weld cable polarity.
2
User-Supplied Female
Connector
3
User-Supplied Male Connector
4
Weld Cable From Wire Feeder
804 229-A
Installing Wire And Adjusting
Hub Tension:
1
Hub Nut
2
Hub Brake Adjusting Knob
Remove hub nut and install spool
so hub pin fits spool hole. Reinstall
hub nut.
Adjust thumb brake knob so only a
slight force is needed to turn spool.
Threading Welding Wire:
3
Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
Open pressure assembly. Hold
wire tightly and cut off end. Push
wire through guides into gun.
Close and tighten pressure assem-
bly. Press Jog switch until wire
comes out gun.
Feed wire against wooden surface,
and tighten knob so wire does not
slip.
Cut off wire, and close door.
Tools Needed:
9/16 in
804 065-A
Publicité
