Publicité
- If you want to obtain a shorter cut, between 1mm and 3mm, use the clipper without any comb (7). If so, set
the cutting height using the regulator (3) on the back of product.
- Turn on the clipper with the ON/OFF button (4) and start cutting.
- Once finished cutting operation, turn off the device using the power button (4), remove any comb and store
the clipper and its accessories out of the reach of children.
RECHARGING
When you first use the product fully charge it, leaving it connected for at least 3.5 hours.
To recharge, connect the USB cable (8) to a suitable USB socket (PC, USB charger, power bank....) and into
the connector on the rear of product (6). During charging, the charge indicator (5) indicates the current level,
and the battery symbol flashes. At the end, the level is 100 and the battery symbol disappears.
The following measures will preserve the battery life.
At first use the product fully charge the product, leaving it connected for at least 3.5 hours. Before you
recharge, completely discharge the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 3.5 hours
before using. In any case it is advisable to fully discharged the battery before recharging. If the appliance,
even after a recharge, works only if it is connected to the cable, it is possible that the battery is no longer
capable of delivering enough power to the unit. In this case, please contact an authorized service center.
MAINTENANCE AND CLEANING
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them or using the small
brush (9). Periodically lubricate the blade by following the steps below. Open the blade set (11), pushing the
blade as shown in figure below. Remove remaining hair by blowing or using the small brush (9).
Use lubricating oil (10) for the blade. 2 or 3 drops are enough if this
operation is carried out frequently.
As shown in the figure, two points must be lubricated with oil:
Put 1-2 drops on the blade (white ceramic). Put 1-2 drops on the driveshaft joint.
Use only the provided oil or similar oil without acids.
Replace the blade set (11) by following the next steps:
-
Insert the tab (B) in the joint (A), as shown in fig. 1.
-
Push the door (2) towards the clipper body until it clicks in position (fig. 2)
Clean the main body by using a soft damp cloth, never immerse the unit in water or
other liquids.
TECHNICAL FEATURES
•
Input DC 5V – 1000mA
•
Cutting height adjustment - Ceramic cutting blade
•
Litium battery, 3.7V - 2000mAh, charging 3.5 hours, lasting 3 hours
•
Accessories: 4 combs, USB cable, lubricating oil, small brush, scissors, comb
7
Publicité
