Publicité
CHECK FILTER FEATURE
This feature is a reminder to clean the air filter (See
Maintenance on page 9) for more efficient operation.
The light above the FILTER RESET button will illuminate
after 250 hours of operation. To reset after cleaning the
filter, press the FILTER RESET button and the light will go
off.
FAULT CODE
If the display reads "
temperature sensor has failed. Contact
Uline Customer Service at 1-800-295-5510.
If the display reads "
temperature sensor has failed. Contact
Uline Customer Service at 1-800-295-5510.
If the display reads "
panel communication has failed.
Contact Uline Customer Service at
1-800-295-5510.
If the display reads "
full. Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away. Restart
the machine until the "
disappears. If error repeats, call Uline
Customer Service at 1-800-295-55100.
PAGE 8 OF 33
OPERATION CONTINUED
EA
," the room
ES
," the evaporator
E4
," the display
P1
," bottom tray is
P1
" symbol
DRAINAGE
During the dehumidifying mode, you will need a
garden hose (sold separately) to drain the condensate
from the unit. Remove the rubber stopper from the hose
connector. (See Figure 21)
The hose may then:
a. Discharge into a drain that is lower than the unit.
b. Be connected to a condensate pump (sold
separately).
Garden Hose
Remove the
Supplied
Rubber
Stopper
Figure 21
0624 IH-5274
Publicité
