Publicité
EXHAUSTING HOT AIR
In cooling mode, the appliance must be placed close
to a window or opening so that the warm exhaust air
can be ducted outside.
Position unit on a flat floor. Ensure there is a minimum
of 12" clearance around the unit and that it is within the
vicinity of a single circuit outlet power source.
1.
Extend either side of the hose. (See Figure 2)
2. Screw the hose onto adapter A. (See Figure 3)
3. Extend the other side of the hose and screw it to
adapter B. (See Figure 4)
4. Slide the assembly onto unit. (See Figure 5)
PAGE 3 OF 33
INSTALLATION
5. Affix adapter B into the window slider kit and seal.
Figure 2
Figure 3
Figure 4
Figure 5
(See Figures 6 and 7)
Vertical
Window
Window Slider Kit
Minimum: 26.6"
Maximum: 48.5"
Horizontal
Window
Window Slider Kit
Minimum: 26.6"
Maximum: 48.5"
NOTE: The hose can be extended from its
original length of 15" up to 59", but it is the best
to keep the length to the minimum required.
Ensure that the hose does not have any sharp
bends or sags. (See Figure 8)
Figure 6
Figure 7
Figure 8
0624 IH-5274
Publicité
