Publicité
6 Slide the spacer sleeve to the harness
loop (6)
6
7 Loosen the screws on the front handle and
slide it onto the drive tube (7)
7
8 Push and rotate the internal drive shaft until
it seats into the powerhead (8)
8
9 Remove the attachment locking screw on
top of the edger attachment (9)
9
12
All manuals and user guides at all-guides.com
Unpacking and Assembly
10 Loosen the clamp screw on the edger
11 Rotate to locate and align to the hole in the
locking screw must be in place and tightened
properly.
12 Tighten attachment clamp screw to 60
13 Align and adjust the front handle for a
ensure guard is present and secured. Replace
guard if it exhibits alteration or damage.
attachment Push and rotate the edger
attachment until it couples with the drive
shaft (10)
10
drive tube Insert the attachment locking
screw/washer and tighten to 60 inch-
pounds
WARNING:
To reduce risk of injury, the
inch-pounds (11)
comfortable working position and tighten
the clamp screw to 50 inch-pounds (12)
Reposition as needed
11
WARNING:
To reduce risk of injury,
Edger Model EG120VX-NA
12
Publicité
