Publicité
Unpacking and Assembly
Unpacking
What's in the boxes?
The edger requires assembly before use. These
items ship with the Edger:
• Powerhead
• Front edger handle
• Drive tube assembly
• Edger attachment assembly
• Combination tool with blocking pin
Remove the edger assemblies from each
box and inspect them carefully to ensure no
damage has occurred during shipping and
that no parts are missing. If any parts are
damaged or missing, do not use the edger.
Contact Oregon
Customer Service to obtain
®
replacement parts at 888.313.8665.
Assembly
Place tool assemblies on a workbench.
1 Remove the powerhead locking screw/
washer on the bottom of the powerhead (1)
Edger Model EG120VX-NA
All manuals and user guides at all-guides.com
Unpacking and Assembly
2 Loosen the recessed control handle clamp
3 Rotate the drive tube to locate and align to
locking screw must be in place and tightened
properly.
4 Tighten the powerhead clamp screws to 60
1
5 Position the control handle so that the
screws (2) and the powerhead clamp
screws (3) Insert the motor housing end of
the drive tube through the control handle
and into powerhead clamp until it is firmly
seated in the powerhead (4)
4
2
the hole in the powerhead Insert the
powerhead locking screw/washer (1) and
tighten to 60 inch-pounds with the included
combination tool
WARNING:
To reduce risk of injury, the
inch-pounds with the included combination
tool
throttle cable is taut (5) Align the control
handle to center the battery indicator over
the drive tube and tighten the recessed
clamp screws to 45 inch-pounds
5
3
1
11
Publicité
