Publicité
Snap Outer table legs 1 (B1) and Inner table legs 1 (C1), into each other in the
Step 9
center groove sec�on, note that the holes are all on one side, and the feet are
all on the same side, and that there are four threaded holes on one side of the
card when it is aligned and one side has no holes.
C1
Align the Connec�ng crossbar (D) into the four holes on the leg side of the table
and lock the bolt (H) into the four holes by slipping it into the spacer (K).
Step 10
Note: When installed, the Connec�ng crossbar (D) has one side with two
holes in the center, and this side is parallel to the table leg holes.
D
B1
B1×1
D×1
H×4
K×4
12
C1×1
Tools:
Q
H
K
Publicité
