Publicité
Charging with Docking – Connect the type C USB plug to
the docking, put the AC150 receiver to the docking.
Charging without Docking – Drect connect the type C USB
plug to the AC150 receiver unit.
Battery low indicator – If a zone LED light is blinking every
10 S, it indicates the battery is low for this transmitter. You
must recharge the battery as soon as possible.
PAIRING & ALARM MELODY
To pair a new device, please follow these steps:
1.Enter pairing mode for the AC150.
Press & hold the LEARNING button (●) for
3 seconds. The LED in zone #1 will flash.
2.Press the LEARNING button (●) again to
move to the zone you wish to pair with.
Press the melody selection ( ) button to
scroll through the melodies. Once you hear a melody you
like, do not press any button during the melody.
3.Once the zone and melody are selected, press one time on
device (AC101,AC110,AC140) button to pair. If successful,
the AMPLICALL150 will generate two short tones.
4.Press the LEARNING button (●) to exit the pairing mode;
the system is now ready to use.
Battery status indicator
LED Light
LED OFF
LED Blink
each 10S
5
Charging
Mode
Charging
Full
Standby
Mode
Normal
Local
Battery Low
Publicité
