ETI Solid State Lighting VAL-SFA Guide D'utilisation Et D'entretien

slip Fitter arm moUnt installation instrUCtion
PackagE conTEnTS
Description
Slip fitter arm mount kit
note: Keep your receipt and these instructions for proof of purchase. To avoid possibility of electrical shock or fire, the installation personnel must
have professional electric knowledge. Please wear gloves to avoid injury before installation. If any smoke or spark of the wire happened, please turn off
the power immediately and notify relevant personnel. Please use listed water proof strain relief bushing when connecting the supply cord to the outlet
box.
WarninG: Shut off the power at the circuit breaker or fuse panel before removing the old fixture, ballast, or fluorescent tubes. Do not use any electric
generator to test the LED light. Please abide by related country, regional and local law and regulations when install this fixture. Please turn off the power
before installation or maintenance. Proper grounding is required to ensure safety. Please check if there is any damage during shipping. If so, please contact
manufacturer timely. Please read the installation instruction carefully to check whether all the accessories are available. After confirmation, install the led
light according to installation steps.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
InSTrucTIon
Remove the bracket mounting screws on the fixture and pass
1
the wires through the bracket.
Connect the wire correctly and put the wires into pole. Then
3
fasten the locking bolts between slip fitter and the pole.
light
Adjusting Bolt
Locking Bolt
WarninG: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could
lead to electric shock, fire, or other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
Use and Care GUide
Quantity
1 Set
±90
SFA Bracket
Support
1-855-ETI-SSLI (1-855-384-7754) www.ETiSSL.com
order # 70336101
Slip fitter arm mount kit
Install the bracket on the fixture.
2
Loosen the fixing bolts and adjusting bolts, align the fixture to
4
required angle. Tighten adjusting bolt and fixing bolts after the
angle is confirmed.
note: Adjustable angle is 0~+/-90°.
part # Val-sFa
Support