Publicité
SAFETY LEASH
1. CONNECTING YOUR LEASH TO THE LIFE LINE
Never launch your kite before connecting your leash to the Life Line.
A) Connecting your leash (standard mode)
Clip the snap hook onto the small buckle of the stainless steel ring at the
end of the Life Line.
B) Connecting your leash (suicide mode)
CAUTION: the standard mode is the only mode which guarantees the
possibility to depower efficiently at any time. F-ONE recommends not
to use the suicide mode which is made to answer the specific needs of
expert riders only.
Fit the Chicken Loop inside the main hole of the stainless
steel ring. Clip the snap hook on the small buckle of the stainless steel ring.
HARNAIS
1
2
3. HOW TO RELEASE THE KITE LEASH
When encountering difficulties, you might need to completely
disconnect the kite from you even after having triggered the
quick-release of your Chicken Loop. To do so, release the kite
leash (tied onto your harness) by pushing the handle in the
direction of the arrow (> 6). The kite will then be completely
disconnected from you.
CAUTION: when fully disconnected, the
kitebar and the lines can hit people located down the wind from
you and cause severe injuries.
4. HOW TO RECONNECT YOUR KITE LEASH
Secure your kite and make sure the lines are not tangled. Thoroughly clean your system (sand...) before
reconnecting. Plug back your leash following the instructions here above.
3
4
STANDARD MODE
2. CONNECTING YOUR LEASH
TO YOUR HARNESS
CAUTION : our safety recommendation is to
secure the leash in front of the harness. Like
this, in case of release, the safety leash remains
accessible.
Trigger the release system of the leash to dis-
connect the metallic pin (1). Pass the rope into
the harness's ring made for it. Reconnect the
Leash by puting the rope into the metallic pin (2).
Then put the metallic pin back into the Leash's
handle (3) & (4).
22
SUICIDE MODE
7
Publicité
