Publicité
Ice Maker and Storage Bin
Turning the Ice Maker On and Off
The ice maker On/Off control is located on the left-hand side of
the ice bin.
1.
To turn on the ice maker, slide the ice maker On/Off control to
the ON (up) position.
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes will fill the ice storage bin. The ice maker
sensors will automatically stop ice production, but the ice
maker control will remain in the ON (up) position.
2.
To manually turn off the ice maker, slide the ice maker On/Off
control to the OFF (down) position as shown.
A
A. On/Off control
Ice Storage Bin Care
1.
Remove the ice bin. See page 10 for instructions.
2.
Empty the ice bin. Use warm water to melt the ice if
necessary.
NOTE: Do not use anything sharp to break up the ice in the
bin. This can cause damage to the ice container and the
dispenser mechanism.
3.
Wash ice bin with warm water and a mild detergent, rinse well
and dry thoroughly. Do not use harsh or abrasive cleaners or
solvents.
IMPORTANT:
„
Allow 24 hours to produce the first batch of ice.
„
Discard the first three batches of ice produced to avoid
impurities that may be flushed out of the system.
„
It may take 3 to 4 days for the ice bin to completely fill, if no
ice is used.
„
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker.
„
Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a softened water
supply cannot be avoided, make sure the water softener is
operating properly and is well maintained.
„
It is normal for the ice cubes to be attached at the corners.
They will break apart easily.
„
Do not store anything inside the ice bin.
Refrigerator Operation
Refrigerator Storage
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter into
many small, pebble-size pieces. This is normal. Glass shelves
and covers are heavy. Use special care when removing them to
avoid impact from dropping.
The shelves and compartments in your refrigerator are adjustable
and/or removable to meet your individual storage needs and to
make them easier to clean.
Storing similar food items together in your refrigerator and
adjusting the shelves compartments to fit different heights of
items will make finding the exact item you want easier. It will also
reduce the amount of time the refrigerator door is open, and help
save energy.
Shelves and Shelf Frames
To remove and replace a shelf/frame:
1.
Remove the shelf/frame by tilting it up at the front and lifting it
out of the shelf supports. Pull the shelf straight out.
2.
Replace the shelf/frame by guiding the rear shelf hooks into
the shelf supports. Tilt the front of the shelf up until the rear
shelf hooks drop into the shelf supports.
3.
Lower the front of the shelf and check to make sure that the
shelf is securely in position.
Deli and Crisper Pans
The refrigerator has one deli pan and one crisper pan. The crisper
pan is the larger of the pans. The crisper pan is good for larger
produce items.
A
B
A. Crisper pan
B. Deli pan
8
Publicité
