Publicité
OPERATING INSTRUCTIONS
1. How to install/tighten threaded fasteners.
Push the switch (D) forward and have the
arrow on the switch (D) pointing at either of the
settings 1, 2, 3 as shown. Press the trigger
(C). The tool anvil (B) runs clockwise.
(See Figure 1)
2. How to remove/loosen threaded fasteners.
Push the switch (D) backward and have the
arrow on the switch (D) pointing at "R" position
as shown. Press the trigger (C). The tool anvil
(B) runs counterclockwise. (See Figure 2)
NOTE
This tool features a power regulator valve.
Turn the switch (D) slowly forward until desired
output is achieved. The Settings 1, 2, 3 do not
denote a specific power output but are only for
reference. "Setting 1" is the least amount of
power, which is suitable for just mounting
threaded fasteners on workpiece while "Setting 3"
is the most amount of power, which is for
tightening threaded fasteners on workpiece. This
tool operates in maximum power in reverse,
which releases threaded fasteners from
workpiece with ease. Choose the correct torque
needed on workpiece when mounting or
releasing threaded fasteners by understanding
the reference torque listed below. (See Figure 3)
Setting
Torque in Forward
1
170 ft-lbs (+/- 10%)
2
280 ft-lbs (+/- 10%)
3
350 ft-lbs (+/- 10%)
All manuals and user guides at all-guides.com
Torque in Reverse
370 ft-lb (+/- 10%)
11
1
2
3
Publicité
